Golink temperature controller manual

TEMPERATURE CONTROLLER OPERATION MANUAL. 1 Before using please check whether range, input and output match your requirement. Thank you for using our microprocessor temperature controller, we have obtained CE certification (LDV: D/N EN; EMC EN 55 /A1:Missing: golink. Operating Temperature. 0 to +50 o C. Product Codes. The codes given below are for standard items kept in stock. Please contact the factory for any controllers required with linear inputs. Please add 'V' to any code for controllers that are required to run from 24V. e.g. VDRELAYV. Temperature Controllers E5CSL/E5CWL/E5EWL The Simple and New Temperature Controller is Released that Easily Achieves the Temperature Control. • Easy to Read (Character Height E5CSL: mm, E5CWL: mm (PV), E5EWL: 20 mm (PV)). † Depth beyond front panel: Only 60 mm. † Fewer parameters for simple setup. † Faster sampling at ms.

When operating the controller it is important to note that you only have approximately seconds between button pushes. If you take longer than 30 seconds, the controller will revert back to displaying the cabinet www.doorway.ru you enter the wrong security code, the controller will revert back to displaying the cabinet temperature. The SOLO Temperature Controller User Manual describes the installation, configuration, and methods of operation of the SOLO Temperature Controller. Who Should Read This Manual This manual contains important information for those who will install, maintain, and/or operate any of the SOLO Temperature Controllers. Technical Support. Temperature Control Module User's Manual-Q64TCTT-Q64TCTTBW-Q64TCRT-Q64TCRTBW-GX Configurator-TC (SW0D5C-QTCU-E) A - 1 A - 1 SAFETY PRECAUTIONS (Read these precautions before using this product.) Before using this product, please read this manual and the relevant manuals carefully and pay full.

A, 15, Jalan Berangan 2/1, Taman Berangan, Sungai Petani, Kedah. [email protected]. * Auto tuning allows the controller to automatically adjust the PID parameter, and is suitable for use when temperature control is not accurate enough. ATVL=auto tuning offset，and it will be deduced from SV (it can prevent over shoot during auto tuning) SV-ATVL=Auto-tuning value，ATVL=auto tuning offset. First you need to use the up and down arrows to adjust the temperature you want to reach. This will appear in the second row of numbers in Green being the SV or Set Value. The top row in Red is the PV or present value and represents the temperature that the Kiln is reading from the thermocouple. 2. Set the Ramp Rate.